Setting up a monument on your own is a difficult task. However, this statement is true only if the person is not familiar with the procedure. So a monument made of polymer granite material (polygon) can be installed in two ways. The first way is easier, but it consists in using the services of the foremen to install monuments. But this method will cost more. The second way is to install the monument manually. We will analyze it.
Instructions
Step 1
In the place of the proposed flower garden, remove the ground to the side, level the site. Then place the flower bed on the ground, leaving an imprint.
Step 2
Lift the flower garden and prepare two iron rods (reinforcement with a diameter of 14-19 mm and a length of 1, 2-1, 4 m). Put the rods on the ground parallel to each other so that the distance between them is 80 cm. The reinforcement should lie at the place where the flower garden is installed, so that from its intended edges to the axis of the reinforcement it is about 15 cm. Then place the flower garden on the reinforcement, and then set it level.
Step 3
Cover the flower garden with earth and tamp all over the cavities. Drive two reinforcing bars with a diameter of 18 mm and a length of 1 m into the ground through the holes in the top of the cabinet. When hammering in the rods, leave an allowance of 15-20 cm above the curbstone.
Step 4
Now prepare a bucket of mortar of sand and cement, taking them in a 6: 1 ratio. Add water at your discretion. Now fill the cabinet with this solution by sticking it through the holes in the cabinet. Now you need to prepare the solution for the obelisk. You will need two buckets of similar solution. It must be flexible enough.
Step 5
Turn the obelisk over, throwing the solution into it. Close the hole of the obelisk with a polyethylene film, and round its edges and secure it to the stele with tape. So, when installing the obelisk, the solution will not fall out. Next, carefully turn the obelisk over and place it on the curbstone, pushing it onto the pins protruding from the curbstone directly through the plastic wrap. Then slightly raise the obelisk, remove the film, then align it in the center and pat it on the flat sides so that the solution squeezes the reinforcement, falling down.
Step 6
Now combine the solution from the obelisk with the solution in the cabinet to form one whole. It remains only to wipe the edges of the monument from the mortar using a rag or soft cloth.
